A practical reference on CJC-1295: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-06-29 and is reviewed periodically as new material appears.
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
Lyophilized peptide powder is comparatively stable when kept dry, cold, and protected from light. Once dissolved, the molecule is vulnerable to deamidation, oxidation, and aggregation, with the rate depending on pH, buffer composition, and temperature. Alkaline conditions and repeated freeze-thaw cycles accelerate loss of the intact peptide. The methionine present in the native sequence is a known oxidation site, which is one reason it was replaced in the modified fragment. Suppliers typically recommend cold storage of solutions and use within a short window.
Analytical confirmation usually relies on reversed-phase high-performance liquid chromatography for purity and on liquid chromatography coupled to mass spectrometry for identity. Mass data reveal the expected molecular mass and can flag truncated or oxidized species. Amino acid analysis and peptide mapping provide sequence-level verification. Immunoassays are used in some biological matrices, but antibodies raised against one releasing-hormone analog may cross-react with another. Reported purity figures depend heavily on the method used, so comparisons between suppliers require matching the analytical approach.
The two variants differ dramatically in how long they persist in circulation. The form lacking the albumin-binding group has a plasma half-life measured in tens of minutes, comparable to the natural hormone fragment. The version carrying the drug affinity complex binds albumin and shows a half-life of roughly six to eight days in human studies. That figure comes from small trials that tracked hormone levels over extended periods. The physiological consequences of sustained versus pulsatile stimulation are still debated and the literature does not settle the point.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white lyophilized powder | Visual descriptor; not a measure of purity |
| Solubility class | Freely soluble in water | Aqueous dissolution may require gentle mixing |
| Typical storage (powder) | −20 °C or below, desiccated | Protect from light and ambient moisture |
| Typical storage (solution) | 2–8 °C, short term | Freeze aliquots where longer holding is needed |
| Purity assessment | Reversed-phase HPLC, area percent | Values depend on column, gradient, and detection wavelength |
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Lyophilized material is typically stored at minus twenty degrees Celsius or lower. Keeping the vial dry and protected from light preserves peptide integrity. Repeated freeze-thaw cycles can cause aggregation or loss of activity. Once dissolved, solutions are generally kept at two to eight degrees Celsius. Stability data for reconstituted solutions vary, and long-term behavior is not fully established. Working aliquots reduce the number of times a stock container is opened.
Reverse-phase high-performance liquid chromatography is the standard tool for purity assessment. The technique separates the target peptide from truncated or modified byproducts. Mass spectrometry confirms molecular weight and supports sequence verification. Electrospray ionization and matrix-assisted laser desorption are both used. Amino acid analysis provides an independent check on composition. Purity values are commonly reported as area percentage from the chromatogram. Residual trifluoroacetate and water content are also measured in many quality programs.
Batch-to-batch consistency depends on solid-phase peptide synthesis and subsequent purification. Coupling efficiency, resin choice, and cleavage conditions all affect the final profile. Counter-ion content and moisture can shift the apparent mass of a batch. Documentation typically includes a certificate of analysis with chromatograms and spectra. Independent verification by a second laboratory is sometimes requested. Whether a given certificate reflects the actual vial contents depends on chain of custody. Analytical methods themselves carry uncertainty that should be stated alongside results.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
During fetal development, some choroid plexus cysts may form. These fluid-filled cysts can be detected by a detailed second trimester ultrasound. The finding is relatively common, with a prevalence of ~1%. Choroid plexus cysts are usually an isolated finding. The cysts typically disappear later during pregnancy, and are usually harmless. They have no effect on infant and early childhood development. Choroid plexus cysts are associated with a 1% risk of fetal aneuploidy. The risk of aneuploidy increases to 10.5-12% if other risk factors or ultrasound findings are noted. Size, location, disappearance or progression, and whether the cysts are found on both sides or not do not affect the risk of aneuploidy. 44-50% of Edwards syndrome (trisomy 18) cases will present with choroid plexus cysts, as well 1.4% of Down syndrome (trisomy 21) cases. ~75% of abnormal karyotypes associated with choroid plexus cysts are trisomy 18, while the remainder are trisomy 21.
Microwave popcorn is a convenience food consisting of unpopped popcorn in an enhanced, sealed paper bag intended to be heated in a microwave oven. In addition to the dried corn, the bags typically contain cooking oil with sufficient saturated fat to solidify at room temperature, one or more seasonings (often salt), and natural or artificial flavorings or both.
== Side effects == Potential side effects of tryptophan supplementation include nausea, diarrhea, drowsiness, lightheadedness, headache, dry mouth, blurred vision, sedation, euphoria, and nystagmus (involuntary eye movements).
Gaddafi married his first wife, Fatiha al-Nuri, in 1969. They had one son, Muhammad Gaddafi (born 1970); their relationship was strained, and they divorced in 1970. Gaddafi's second wife was Safia Farkash, née el-Brasai, a former nurse from the Obeidat tribe, born in Bayda. They met in 1969, after his ascension to power, when he was hospitalized with appendicitis; he claimed that it was love at first sight. The couple remained married until his death. Together they had seven biological children: Saif al-Islam Gaddafi (1972–2026), Al-Saadi Gaddafi (born 1973), Mutassim Gaddafi (1974–2011), Hannibal Muammar Gaddafi (born 1975), Aisha Gaddafi (born 1976), Saif al-Arab Gaddafi (1982–2011), and Khamis Gaddafi (1983–2011). He also adopted two children, Hana Gaddafi and Milad Gaddafi. Several of his sons gained a reputation for lavish and anti-social behaviour in Libya, which proved a source of resentment toward his administration. At least three of his cousins were prominent figures in Gaddafi's regime. Ahmed Gaddaf al-Dam is Libya's former Special Envoy to Egypt and a leading figure of the Gaddafi regime. Mansour Dhao was his chief of security and led the People's Guard. Sayyid Gaddaf al-Dam was a brigadier general and described as the second most powerful person in Libya in the 1980s. Saif al-Islam Gaddafi, the son who was considered to be Gaddafi's main heir, was assassinated in February 2026.
Sources: en.wikipedia.org
Increasing temperature, which evens out the Boltzmann population of states. Conversely, low temperature NMR can sometimes yield better results than room-temperature NMR, providing the sample remains liquid. Saturation of the sample with energy applied at the resonant radiofrequency. This manifests in both CW and pulsed NMR; in the first case (CW) this happens by using too much continuous power that keeps the upper spin levels completely populated; in the second case (pulsed), each pulse (that is at least a 90° pulse) leaves the sample saturated, and four to five times the (longitudinal) relaxation time (5T1) must pass before the next pulse or pulse sequence can be applied. For single pulse experiments, shorter RF pulses that tip the magnetization by less than 90° can be used, which loses some intensity of the signal, but allows for shorter recycle delays. The optimum there is called an Ernst angle, after the Nobel laureate. Especially in solid state NMR, or in samples containing very few nuclei with spin (diamond with the natural 1% of carbon-13 is especially troublesome here) the longitudinal relaxation times can be on the range of hours, while for proton-NMR they are often in the range of one second. Non-magnetic effects, such as electric-quadrupole coupling of spin-1 and spin-3/2 nuclei with their local environment, which broaden and weaken absorption peaks. 14N, an abundant spin-1 nucleus, is difficult to study for this reason. High-resolution NMR instead probes molecules using the rarer 15N isotope, which has spin-1/2.
=== Distribution === Following absorption, 2,6-DCBQ distributes predominantly to highly perfused organs, such as the liver and the kidneys. Its moderate lipophilicity facilitates the crossing of cellular membranes. The quinone structure allows for redox cycling between quinone and hydroquinone within tissues. This process can lead to the formation of reactive oxygen species (ROS), contributing to intracellular oxidative stress. Due to its high reactivity and its metabolic transformation, 2,6-DCBQ does not significantly accumulate in adipose tissue.
A gene is a sequence of DNA that contains genetic information and can influence the phenotype of an organism. Within a gene, the sequence of bases along a DNA strand defines a messenger RNA sequence, which then defines one or more protein sequences. The relationship between the nucleotide sequences of genes and the amino-acid sequences of proteins is determined by the rules of translation, known collectively as the genetic code. The genetic code consists of three-letter 'words' called codons formed from a sequence of three nucleotides (e.g., ACT, CAG, TTT). In transcription, the codons of a gene are copied into messenger RNA by RNA polymerase. This RNA copy is then decoded by a ribosome that reads the RNA sequence by base-pairing the messenger RNA to transfer RNA, which carries amino acids. Since there are 4 bases in 3-letter combinations, there are 64 possible codons (43 combinations). These encode the twenty standard amino acids, giving most amino acids more than one possible codon. There are also three 'stop' or 'nonsense' codons signifying the end of the coding region; these are the TAG, TAA, and TGA codons, (UAG, UAA, and UGA on the mRNA).
Sources: en.wikipedia.org
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.
There is no single agreed limit, and laboratory practice varies widely. Refrigeration slows degradation, and freezing aliquots is often described for longer holding. Any visible cloudiness or precipitate indicates the solution should be discarded.
Mass spectrometry provides the most direct confirmation through molecular mass. Reversed-phase chromatography supports purity assessment, and peptide mapping or amino acid analysis can corroborate sequence. No single method establishes both purity and identity on its own.
The version carrying the affinity complex bears a maleimide group that binds serum albumin, which extends its circulation time to several days. The version without it lacks this group and clears within roughly half an hour. The two are chemically related but behave very differently once in the body.