This is a working overview of mass spectrometry, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-01-24 and is reviewed periodically as new material appears.
CJC-1295 is a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. Its sequence corresponds to the first twenty-nine residues of human GHRH, with four substitutions that slow enzymatic breakdown. Early descriptions placed the compound in research on growth hormone deficiency and related conditions, and later literature groups it with the long-acting GHRH analogs. The name appears in both laboratory and popular fitness writing, where it sometimes labels chemically different peptides.
Two related peptides circulate under the CJC-1295 label, and they differ mainly in how long they persist in circulation. The version carrying a drug affinity complex includes a maleimidopropionic acid linker that forms a covalent bond with serum albumin. The other version, usually written as modified GRF(1-29) or tetrasubstituted GRF(1-29), lacks that linker and is cleared quickly. Mixing the two produces inconsistent readings of published half-life values, because the linker rather than the receptor-facing sequence drives most of the difference.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
Reconstitution is typically performed with sterile water or bacteriostatic water, added slowly against the vial wall. The resulting solution should be clear and colorless; cloudiness or visible particles suggest a problem with the material or the diluent. Once in solution, the peptide is less stable than the dry powder. Refrigerated storage at two to eight degrees Celsius is common for short-term holding, while freezing aliquots is described for longer periods.
| Property | Value | Notes |
|---|---|---|
| Class | Synthetic peptide | GHRH receptor agonist |
| Sequence length | 29 amino acids | Derived from human GHRH |
| Molecular weight | About 3368 Da without linker | Albumin-binding form is heavier |
| Appearance | White to off-white lyophilized powder | Common form for research reference material |
| Typical storage | -20 °C or below, desiccated | Protect powder from light and moisture |
Lyophilized material is typically stored at minus twenty degrees Celsius or lower. Keeping the vial dry and protected from light preserves peptide integrity. Repeated freeze-thaw cycles can cause aggregation or loss of activity. Once dissolved, solutions are generally kept at two to eight degrees Celsius. Stability data for reconstituted solutions vary, and long-term behavior is not fully established. Working aliquots reduce the number of times a stock container is opened.
Reverse-phase high-performance liquid chromatography is the standard tool for purity assessment. The technique separates the target peptide from truncated or modified byproducts. Mass spectrometry confirms molecular weight and supports sequence verification. Electrospray ionization and matrix-assisted laser desorption are both used. Amino acid analysis provides an independent check on composition. Purity values are commonly reported as area percentage from the chromatogram. Residual trifluoroacetate and water content are also measured in many quality programs.
Batch-to-batch consistency depends on solid-phase peptide synthesis and subsequent purification. Coupling efficiency, resin choice, and cleavage conditions all affect the final profile. Counter-ion content and moisture can shift the apparent mass of a batch. Documentation typically includes a certificate of analysis with chromatograms and spectra. Independent verification by a second laboratory is sometimes requested. Whether a given certificate reflects the actual vial contents depends on chain of custody. Analytical methods themselves carry uncertainty that should be stated alongside results.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
CJC-1295 is a synthetic peptide designed to mimic growth hormone-releasing hormone (GHRH), the endogenous signal that prompts the pituitary gland to release growth hormone. The compound is a modified fragment of the natural hormone, spanning the first twenty-nine amino acids of GHRH with several substitutions that slow enzymatic breakdown. Two variants circulate in research settings: one carrying a drug affinity complex (DAC) and one without it. The DAC-free form is frequently labelled Mod GRF(1-29) in catalogs and discussion forums.
The peptide binds GHRH receptors on somatotroph cells within the anterior pituitary, triggering a signalling cascade that increases growth hormone secretion. Its improved resistance to dipeptidyl peptidase IV degradation distinguishes it from the parent hormone. In the DAC-bearing version, a maleimide group reacts with a cysteine residue on serum albumin, forming a covalent bond that keeps the peptide in circulation far longer. That albumin attachment is the central design feature separating the two research variants.
Pharmacokinetic behaviour differs sharply between the two forms. The DAC-bearing peptide shows an extended circulation time measured in days, whereas the version without the complex is cleared within roughly half an hour. This gap shapes how researchers design dosing schedules in animal models. Whether the prolonged presence of the DAC form produces effects meaningfully different from the short-acting variant remains an open question, since comparative human data are scarce.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
=== World War II === After the appointment of Adolf Hitler as chancellor in 1933, IG Farben cooperated with the National Socialist government, profiting from guaranteed volumes and prices and, in time, from forced ("unfree") labour provided through governmental concentration camps. BASF (leader of the chemical industry of the IG Farben) built a 24 km2 chemical factory in Auschwitz named "IG Auschwitz", the largest chemical factory in the world at the time. IG Farben became notorious through its production of Zyklon-B, the lethal gas used to kill prisoners in German extermination camps during the Holocaust. IG Farben made extensive use of forced labor during WWII consisting mostly of drafted "service-duty" Germans, foreign workers from German-occupied territories, and prisoners of war. By 1943, nearly one-half of all IG Farben workers were forced laborers housed in factory-camp facilities. This number did not include the 51,445 concentration camp laborers supplied by the Nazis. Spread out over 23 facilities, it is estimated that 31,500–33,500 of those concentration camp inmates were killed by authorities or died from starvation, exhaustion, or disease. The Ludwigshafen site was almost completely destroyed during the Second World War but was subsequently rebuilt. The allies dissolved IG Farben in November 1945. Both the Ludwigshafen and Oppau plants were of strategic importance for the war because the German military needed many of their products (e.g., synthetic rubber and gasoline). As a result, they were major targets for air raids.
=== Random selenocystine === Just as selenomethionine can be randomly incorporated into proteins, selenocystine can also be mistakenly attached to tRNACys by cysteinyl-tRNA synthetase and incorporated into proteins in lieu of cystine. This causes considerable toxicity. A variant synthase that can distinguish between Cys and Sec helps reduce toxicity. This toxicity may be one reason for the existence of a rather complicated pathway of selenocysteine biosynthesis and specific incorporation into selenoproteins (described above), which avoids the occurrence of the free amino acid as intermediate. Due to this pathway, even if a selenocysteine-containing selenoprotein is taken up in the diet and used as selenium source, the selenocysteine residue is not reused directly.
=== Limitations and exemptions === There are limited exceptions and exemptions. For instance, the Single Convention provides exceptions to the central "exclusively to medical and scientific purposes" rule, such as for the cultivation of industrial hemp, the use of the coca leaf as a flavoring agent, and a general exemption in article 2(9) of any drug used for "other than medical and scientific purposes" (a phrase with conflicting interpretations). Countries can also join the treaties with specific national reservations.
=== Protein analysis === Protein analysis using microPIXE allow for the determination of the elemental composition of liquid and crystalline proteins. microPIXE can quantify the metal content of protein molecules with a relative accuracy of between 10% and 20%. The advantage of microPIXE is that given a protein of known sequence, the X-ray emission from sulfur can be used as an internal standard to calculate the number of metal atoms per protein monomer. Because only relative concentrations are calculated there are only minimal systematic errors, and the results are totally internally consistent. The relative concentrations of DNA to protein (and metals) can also be measured using the phosphate groups of the bases as an internal calibration.
Sources: en.wikipedia.org
Strontium commonly occurs in nature, being the 15th most abundant element on Earth (its heavier congener barium being the 14th), estimated to average approximately 360 parts per million in the Earth's crust and is found chiefly in two mineral forms: the sulfate (celestine, SrSO4) and the carbonate (strontianite, SrCO3). Of the two, celestine occurs much more frequently in deposits of sufficient size for mining. Because strontium is used most often in the carbonate form, strontianite would be the more useful of the two common minerals, but few deposits have been discovered that are suitable for development. Because of the way it reacts with air and water, strontium only exists in nature when combined to form minerals. Naturally occurring strontium is stable, but its synthetic isotope Sr-90 is only produced by nuclear fallout. In groundwater, strontium behaves chemically much like calcium. At intermediate to acidic pH, Sr(2+) is the dominant strontium species. In the presence of calcium ions, strontium commonly forms coprecipitates with calcium minerals such as calcite and anhydrite at an increased pH. At intermediate to acidic pH, dissolved strontium is bound to soil particles by cation exchange. The mean strontium content of ocean water is 8 mg/L. At a concentration between 82 and 90 μmol/L of strontium, the concentration is considerably lower than the calcium concentration, which is normally between 9.6 and 11.6 mmol/L. It is nevertheless much higher than that of barium, 13 μg/L.
==== Granule membrane fusion ==== The mast cell granule can now fuse with the plasma membrane. This is mediated by Soluble N-ethylmaleimide-sensitive factor attachment protein receptors (SNARE) proteins. Different SNARE proteins interact to form different complexes that catalyze fusion.
=== Other reactions of biochemical significance === Homocysteine can cyclize to give homocysteine thiolactone, a five-membered heterocycle. Because of this "self-looping" reaction, homocysteine-containing peptides tend to cleave themselves by reactions generating oxidative stress. Homocysteine also acts as an allosteric antagonist at Dopamine D2 receptors. It has been proposed that both homocysteine and its thiolactone may have played a significant role in the appearance of life on the early Earth.
Sources: en.wikipedia.org
Natural GHRH is degraded quickly by dipeptidyl peptidase-4 and related enzymes, giving it a half-life measured in minutes. CJC-1295 carries substitutions that slow that breakdown, so it stays intact longer. Both act at the same pituitary receptor and produce the same class of signal.
The label was first attached to the albumin-binding form during early development work. A shorter analog without the linker later became known by the same name in informal use. Published papers normally state which version was studied, so the methods section resolves the ambiguity.
It is a synthetic peptide rather than a steroid, and it does not occur naturally in the body. Its sequence is derived from a hypothalamic hormone called growth hormone-releasing hormone. It works as a receptor agonist rather than as a replacement for that hormone.
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.